Heat gun buying guide
Updated: 21.10.2026
You are about to buy a first corded heat gun from amazon.co.uk, and the titles are shouting 2000 W. That number does not tell you whether you can hold the air under 500°C, whether the listing states 230 V, or whether a scraper is in the box. Run this check before you sort the [hot air gun comparison](/hub/compressors/hot-air-gun) by price. The figures are the listings in that set on 19 October 2026. It is not a lab test. Entry guns here sit at about £13.99 to £19.99. What you can verify is the control, the stated steps, the supply line and the included parts.
You are about to buy a first corded heat gun from amazon.co.uk, and the titles are shouting 2000 W.
You are about to buy a first corded heat gun from amazon.co.uk, and the titles are shouting 2000 W. That number does not tell you whether you can hold the air under 500°C, whether the listing states 230 V, or whether a scraper is in the box. Run this check before you sort the hot air gun comparison by price. The figures are the listings in that set on 19 October 2026. It is not a lab test. Entry guns here sit at about £13.99 to £19.99. What you can verify is the control, the stated steps, the supply line and the included parts.
Our top picks
| Badge | Product | Temperature control | Stated temperature | Supply | Note | Price | Offer |
|---|---|---|---|---|---|---|---|
| Best overall |  BLACK+DECKER BLACK+DECKER KX1650-GB | Two fixed settings | 570°C and 740°C | 230 V corded | 5.5 | about £18 | View offer |
 SEEKONE SEEKONE SDL-2816 | Variable dial plus high/low airflow | 50–600°C | Mains; voltage not stated | 8.1 | about £25.99 | View offer | |
| Best value |  SEEKONE SEEKONE HG886 | Two fixed settings | 400°C and 600°C | 220 V stated | 6.3 | about £16.99 | View offer |
On this page
Two settings or a dial
A two-setting gun gives you a fixed low and a fixed high. A variable gun gives you a dial, usually with two airflow steps. Adjustable on a title is not the same thing. The JFTOOIS V-F3000A says adjustable and then describes a two-gear button, with no degree steps at all. The AIUNAOM HG02 title says two temperature settings while the bullets also say nine. Read the numbers, then decide which sentence you believe.
Keep a hot-air gun below 500°C where paint may contain lead, and do not use a blow lamp or a gas torch. On this capture the BLACK+DECKER KX1650-GB states 570°C and 740°C, so both steps fail that filter. The SEEKONE HG886 states 400°C and 600°C, so only the low step can pass. The SEEKONE SDL-2816 and the JOJOREC Hg2600 state a dial from 50°C up to 600°C. Technique for gloss sits on the heat gun paint stripping page, not here.
Voltage and the UK plug
UK mains are 230 V. For a domestic flex, the Electrical Equipment (Safety) Regulations 2016, regulation 35, point to a BS 1363 plug and a BS 1362 fuse. Electrical Safety First asks for a UK 3-pin plug on a cabled heat gun. A listing that says 220 V is not that check. It does not name the plug in the box.
In this set only the BLACK+DECKER KX1650-GB and the COMTO SG-1004 state 230 V. The JFTOOIS, the URTOOLS and the SEEKONE HG886 state 220 V. The variable SEEKONE SDL-2816 and the JOJOREC omit voltage. The COMTO states 230 V AC and a 1.8 m cord, and still does not name BS 1363. A two-pin Schuko that needs an adaptor is a buying problem, not a footnote you solve with tape.
Nozzles, scraper, cable and a stand
Paint wants a wider airflow and a scraper. Heat-shrink wants a reflector or a concentrator, and a lower step than a paint-stripping high. Count the included-components line, not a lifestyle photo. The BLACK+DECKER line is the gun, and reviewers say no attachments were in the box. The SEEKONE SDL-2816 lists five nozzles, a scraper and a putty knife. The SEEKONE HG886 lists four nozzles and no scraper. The JOJOREC bullet lists nozzles, a scraper and shrink tubes, while a specification line says the box is the heat gun only.
The variable SEEKONE states 5.25 ft, and reviewers often call these leads short. Use a fully unwound reel, so the reel itself does not become the hot part. A stand is not a reason to leave the gun running. The WORKPRO 7.2 V is a cordless craft gun reviewers called too cool for thick shrink wrap, and the Beyondlife BYHQ at £194.99 is a plastic welder, not a paint gun.
What this Amazon set can and cannot show
This set can show a dial against a two-step gun, a stated 230 V line against a blank voltage field, and a review file of thousands against a file of 67. It cannot show a measured nozzle temperature, a BS 1363 plug where the listing is silent, or a UK-wide best.
Watch three conflicts. The URTOOLS title says 1600 W and the wattage field says 1300 watt-hours. The AIUNAOM HG02 title says two settings and the bullets also say nine. The JOJOREC box line disagrees with its accessory bullet. A claimed first-use smoke is an instruction to ventilate, not a certificate that the smell is harmless. For paint that might contain lead, start with a stated step under 500°C, then read the best heat gun UK page for who each pick is for.
Common questions
Do I need 2000 W?
No. The BLACK+DECKER is 1750 W with steps of 570°C and 740°C. Watts do not tell you whether the low step can stay under 500°C, which is the filter that matters on older paint. Buy the stated steps first.
Are two settings enough for paint?
They can be, for modern gloss, if the low step is one you can live with and you keep the gun moving. They are not enough when the only stated steps are already above 500°C and the paint may contain lead. In this set that is the BLACK+DECKER pair of 570°C and 740°C.
What does variable mean if the title also says two-gear?
It may mean a button with two fixed outputs, not a dial. The JFTOOIS title says adjustable and two-gear button control, and it states no degree steps. The AIUNAOM HG02 title says two settings and the bullets also say nine. Treat variable as a claim until the listing prints the steps you can actually select.
Why do some listings say 220 V?
A 220 V line is not proof of a UK plug. Regulation 35 expects a BS 1363 plug and a BS 1362 fuse on a domestic flex, and Electrical Safety First asks for a UK 3-pin plug on a cabled heat gun. In this Amazon set only the BLACK+DECKER and the COMTO state 230 V. Check the plug in the box before you rely on the listing.
How many nozzles do I need?
One wide nozzle and a scraper cover a lot of gloss. Heat-shrink wants a reflector or a concentrator, which a paint-only kit may not include. The BLACK+DECKER included line is the gun alone. The variable SEEKONE lists five nozzles plus a scraper and a putty knife. Count the included-components line, and treat a conflicting bullet as unresolved.
Related pages
Sources
Public UK sources below. amazon.co.uk listings checked on 19 October 2026.
- HSE: Lead in construction (retrieved 19 October 2026)
- HSE: CIS79 Old lead paint (retrieved 19 October 2026)
- legislation.gov.uk: Electrical Equipment (Safety) Regulations 2016, regulation 35 (retrieved 19 October 2026)
- GOV.UK: Electrical Equipment (Safety) Regulations 2016, Great Britain (retrieved 19 October 2026)
- Electrical Safety First: Heat guns (retrieved 19 October 2026)
- Met Office: Frozen or burst pipes (retrieved 19 October 2026)
- Northern Ireland Housing Executive: Cold weather ready (retrieved 19 October 2026)
- Vehicle Wrapping Academy: Steinel HG 2120 E (retrieved 19 October 2026)